_CAUTtON'
Before
performing
any
service
and adjustments:
•
Release
control bar and stop engine.
•
Make sure the blade and all moving
parts have completely
stopped.
•
Disconnect
spark plug wire from spark
plug and place where
it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST
CUTTING HEIGHT
See "TO ADJUST CUTTING
HEIGHT" in the
Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear
wheels of your lawn mower, is provided to
minimize the possibility that objects will be
thrown out the rear of [he lawn mower into the
operator's mowing position,
If the rear
deflector becomes
damaged, it should be
replaced.
TO REMOVE/REPLACE
DRIVE BELT
,, Remove drive cover.
Remove belt by
pushing down on gear case pulley and roll
belt off.
• Turn lawn mower on its side with carbure-
tor and fuel cap up.,
o Remove
blade,
o Remove
debris shield.
,, Remove belt from engine pulley on
crankshaft,
o Install new belt by reversing above steps,
° Always use factor,/approved
belt to assure
fit and long life.
TO ADJUST
HANDLE
The handle
can be mounted
in a high or
tow position.
Tile mounting
holes in the
bottom
of lower handle
are off center for
raising
or lowering
the handle.
,, Remove
upper handle
and all parts
attached
to !ower handle.
o Remove
hairpin
cotters
from lower
handle
bracket
mounting
pin°
° Squeeze
!ower handle
in to remove
it
from mounting
pins,
° Turn lower
handle over to raise or lower
handle.
,, Squeeze
lower
handle
in and position
holes onto mounting
pins on handle
bracket.
• Reassemble
upper handle
and all parts
removed
from
lower handle,
Mowing
,_.
Mowing
/(i'
position
:-
position
;,_
,
t
Low position
High position
Drive
cover
Belt
Push
down
Rotate
I4