Immediately
prepare your lawn mower for
storage at the end of the season or if the unit
will not be used for 30 days or more.
LAWN MOWER
When lawn mower is to be stored for a period
of time, clean it thoroughly, remove all dirt,
grease, leaves, etc+ Store in a clean, dry area.
° Clean entire lawn mower (See "CLEAN+
tNG" in the Maintenance
section of this
manual).
° Lubri,cate as shown in tl_e Maintenance
section of this manual
• Be sure that all nuts, bolts, screws, and pins
are securely fastened,
Inspect
moving
parts for damage, breakage and wear.
Replace if necessary°
• Touch up al! nJsted or chipped paint
surfaces; sand lightly before painting,
HANDLE
You can fo_d your lawn mower handle for
storage.
• Squeeze the bottom ends of tile lower
handle toward each other until the lower
handle clea+s the handle bracket, then
move handle forward.
. Loosen upper handle mounting
bolts
enough to allow upper handle to be folded
back.
IMPORTANT:
When folding the handle for
storage or transportation,
be sure to fold the
handle as shown or you any damage tile
control cables.
o When setling up your handle fiom the
storage position, the lower handle wilt
automatically
lock into the mowing position,.
Lower
handle
Squeeze to fold
Handle
bracket
Hairpin
cotter
Operator presence control bar
Fold foward
for storage
Upper
handle
Fold
backward
Lower
Mowing
handle
position
ENGINE
FUELSYSTEM
IMPORTANT:
It is important to prevent gum
deposits from forming in essential fuel system
pa+ls such as carburetor, f fuel filter; fuel hose
or tank during storage. Also, experience
indicates that alcohol blended fuels ( called
gasohol or using ethanol or methanol) can
attract moisture which leads to separation and
formation of acids dudng storage. Acidic gas
can damage the fuel systern of an engine
while in storage.
• Drain the fuel tank°
• Start the engine and let it run until the fuel
lines and carburetor are empty.
o Never use engine or carburetor cleaner
products in the fuel tank or permanent
damage
may occur.
° Use flesh fue! next season.
NOTE"
Fuel stabilizer is an acceptable
alternative in minimizing the formation of fuel
gum deposits during storage,
Add stabilizer
to gasoline in fuel tank or storage container.
Always follow the mix ratio found on stabilizer
container.
Run engine at least 10 minutes
after adding stabilizer to allow the stabilizer to
reach the carburetor.
Do not drain the gas
tank and carburetor if using fuel stabilizer.
16