Operation Of The Device; Charging Via Usb - CASO DESIGN Sound & Cool 790 Manual De Instrucciones

14.2 Operation of the device

Temperature Setting.
Plug in the power plug.
Press the unlock key for 3 seconds.
Press
Press
With OF the respective drawer can be switched off.
When the Sound & Cool is switched on you can change the temperature of the drawers by
unlocking the panel for the drawers. Press
temperature. The two control panels are working independently from each other.
The temperature in the device depends on the room temperature, the quantity of bottles/
amount of food and the chosen temperature. Please note that your device is intended to cool
food and beverages. The maximum temperature that can be reached inside the device
cannot be significantly ABOVE the ambient temperature at the setup location.
When you open the drawer the actual temperature is displayed.
► The device beeps when the drawers is opened too long and the display shows DR to
remind you to close the drawer.
► Let the device work for 2 hours before placing food/beverages into the device.
► If not further operation is performed within 2 seconds, then the displayed temperature is
confirmed and stops flashing.
Eco Mode
Press button for 3 seconds until ECO is displayed. The temperature for both
drawers is set to 5 °C automatically.

14.3 Charging via USB

As soon as the device is switched on, you can charge via the two USB ports.
for setting of temperature (1-12) of left drawer.
for setting of temperature (1-12) of right drawer.
Please note
for 3 seconds and then set desired
41