Sears 358.799211 Manual Del Usuario página 17

e. ACCELERATION CHECK
L Allow engine to idle. Be sure the trimmer
line is extended to the maximum length al-
lowed by the line limiter.
2. Squeeze trigger fully:
a.) If performance is satisfactor_ pro-
eeed to "d. Deceleration Cher_k."
b:) If the engine does not accelerate
smoothl_ turn the _ screw
counterclockwise a small mount (no
more than the width of the slot in the ad-
justing
screw).
3. Repeat step"2."until smooth acceleration
is obtained. Do not attempt to adjust the
screw beyond the stops as damage can occur.
NOTE." It may be necessary to repeat "Idle Speed
Adjustment" through "Acceleration Check," to
obtain correct adjustments.
4. Follow the instructions in the "Decelera-
tion Check _ section.
d. DECELERATION CHECK
1. Allow engine to idle. Be sure the trimmer
line is extended to the maximum length al-
lowed by the line limiter.
2. Squeeze throttle trigger fully.
3. Allow the engine to mn at full speed for
about i second.
4. Release thethrottle t rigger t otheidle posi-
tionand listen tothedeceleration oftheen-
gine. It must retm'n to idlesmoothly and
within I to2 seconds.
a. If performance is satisfaetor_ no
further adjustments are necessary.
i i | i
b. If the eng_. e slowly or erratically
returns to idle or idles erratically,
proceed to Mixture Adjustment.
e. MIXTURE ADJUSTMENT
DO not operate engine at full
r p r?longed periods while mak-
g mLxture adjustments as damage to the
engine can occur.
I. Support the lower end so the trimmer line
is off the ground and will not make contact
with any object. Be sure the trimmer line is
extended to the maximum length allowed
by the line limiter.
2. Start the engine. Allow engine to idle, then
squeeze throttle trigger R_ly.
NOTE.. Perform steps "3." through "5." at full throt-
tle,
3. Turn mixture screw (Figure21) very
slowly clockwise until engine speed is re-
duced.
4. Turn mixture screw very slowlycounter.
clockwise. Stop when the enginebeginsto
runroughly.
5. Turn screw slowly the minimum mount
clockwise until engine runs smoothly. Do
not a_tempt to adjust the screw beyond the
stops as damage can occur.
6. Follow instructions in "Acceleration
Check" and "Deceleration Check".
[ CAUTION; IIf the engine does not operate ac-
cording to these instructions after repeat-
mg the adjusting steps, do not use the tool.
Take _t to your nearest SEARS Service Cen-
ter/Department.
H i i , H,H, HI
E. SPARK PLUG -- Replace the
spark plug yearly.
H HH HI HI HH IHI, H
NOTES
-17-