4
Press the
or
then press the ENTER
•
Air : "Air" antenna signal
Cable : "Cable" antenna signal
Air+Cable : "Air" and "Cable" antenna signals
When selecting Cable TV system:
Press the ENTER
By default, the cable TV system is set to "STD".
If you want to select another type of cable system,
press the
or
button to select "STD", "HRC" or "IRC".
•
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
At this point the signal source has been selected.
5
Press the ENTER
The TV begins memorizing all available stations.
Press the ENTER
memorization process.
Select "Return" by pressing the
press the ENTER
menu. Press the EXIT button to exit.
•
The TV must be connected to an antenna/cable in order to receive digital
TV signals. Even if a particular channel is deleted from the memory,
you can always tune to that channel directly by using the number buttons on the
remote control.
•
When connecting Digital Cable to a Set-Top Box, Channel Memorization is
done on the STB.
To view the STB on your TV, select the Input jack the STB is connected to with the
SOURCE button on the remote control. (see page 32)
All available DTV and analog channels are automatically stored in memory.
button to select the Antenna connection,
button.
button to start the auto program.
to start the auto program.
button at any time to interrupt the
or
button, then
button to return to the previous
English-21