Routine Maintenance - Ingersoll Rand BC1110 Especificaciones Del Producto

Completely charge new battery packs before using. Charging time is approximately 60-90 minutes.
Unplug charger and remove battery pack when not in use.
Action
Plug
charger
into
Power On (Stand-By).
100-240V
AC power
outlet.
Charging.
Insert
battery Fuel gage will indicate state
pack into of charge.
Communications Failure.
charger.
Battery Identification/Read
Fault. Reinsert battery. Battery
may be defective.
Initial Temperature.
Charging paused until
battery has returned to safe
temperature.
Time Out.
Charge time exceeded. Battery
may be defective.
In Cycle Temperature.
Charging paused until
battery has returned to safe
temperature.
Over Voltage.
High voltage detected. Battery
may be defective.
Over Current.
High current detected. Battery
may be defective.
Charge Completed
Remove
Battery Pack Removed.
battery
pack.
Legend:
ä Flash l On m Off
Environmental Protection
When life of Ingersoll Rand electrical product has expired, it must be recycled in accordance with all applicable
standards and regulations (local, state, country, federal, etc.). Improper disposal may endanger environment.

Routine Maintenance

Unplug charger before cleaning. Plastic surfaces should only be cleaned with a slightly damp
cloth. Keep vents free of dust and debris.
Charger should not be used with a damaged cord. Replacement cords and labels are available at
nearest authorized Ingersoll Rand Service Center.
Refer all communications to nearest Ingersoll Rand Office or Distributor.
23794902_ed5
Charger Display
Condition
BC1110
Charger
Green Red Green
1 x ä 1 x ä
l
m l
ä
m l m
2 x ä
m m
3 x ä
m m
4 x ä
m m
5 x ä
m m
6 x ä
m m
l m l
1 x ä 1 x ä
l
BC1120, BC1121 & BC1161
Alarm
Display
(Sound)
Red
-
m
-
m
Low ♪ mmmm
l
Low ♪ mmmm
2 x ä
Low ♪ mmmm
3 x ä
Low ♪ mmmm
4 x ä
Low ♪ mmmm
5 x ä
Low ♪ mmmm
6 x ä
High ♪
m
High ♪
m
EN
Fuel
Gauge
mmmm
ämmm
Ê
llll
---
EN-2