Operating Instructions; Temperature Regulation; Continuous Operation; Cleaning - Euromax 1134 Manual De Instrucciones

ENGLISH
Only connect the equipment to an earthed power supply!
Make sure the mains electric supply has a 30mA protection and a circuit breaker with 3 mm space
between the contacts.
Do not connect the equipment to the mains electricity supply by a multi-socket adapter or an
extension lead.
All installation works must strictly comply with current local and national safety regulations.
Connect the power cable to an earthed power supply.

4. Operating instructions

Never operate the equipment with wet hands!
The tray must always be inserted when the toaster is working
Take off the handles of the grids and the pincers when the toaster is working
Always use the pincers for putting bread onto the grids.
Danger of scalding and burning! Do not touch the grids or other metallic parts while the equipment
is working or still hot.
In case water or any other liquid is accidently spilled over the grill, immediately disconnect it from
the electric supply and let it dry completely before connecting it again.
 Before toasting bread for the first time, turn on the equipment at maximum heat for about 10-15
minutes in order to evaporate any existing humidity.
4.1.

Temperature regulation

In order to change the temperature, turn the rotative knob of the timer to the desired position. Then
press the switch(s) for the desired levels.
4.2.

Continuous operation

In order to activate the continuous heating turn the rotative knob of the timer to the left until it points
to the position "C".

5. Cleaning

Always disconnect the equipment from the power supply before proceeding to any cleaning
intervention.
Do not use jets of water to clean the equipment. Do not pour water onto the equipment or onto
any of its attached components.
Before cleaning, let the equipment cool down!
Do not use solvent, abrasive or acid detergents on the equipment!
1. Clean the cooled down tray and grids with water and some liquid detergent.
2. Clean the exterior of the toaster with a soft humid cloth.
6. Maintenance 
Only suitably qualified and competent persons may install and repair the contact grill. Repairs and
other work by unqualified persons are dangerous and the manufacturer will not be held liable for
any resulting damage.
Installation and repair works must strictly comply with current local and national safety regulations.
Substituting of the power cable 
6.1.
In case the power cable gets damaged, substitute it with the following cable types:
One level toaster: H07RN-F 3G 1 mm
Two level toaster: H07RN-F 3G 1,5 mm
2
;
2
.
11
Toaster – Operating Manual