1. Access the drive bays by
sliding the faceplate up until it
unlatches from the device.
2. Once the faceplate is unlatched,
pull it off of the device, exposing
the drive bays.
3. Insert a 3.5" SATA hard drive into
each available drive bay. Make
sure to align the drive connectors
to the endpoints in the DNS-323.
Gently push the drive in until it
connects.
Note: If only one 3.5" SATA drive is available place this drive in the LEFT
bay while the opening (front) of the DNS-323 is facing you.
5
Hardware Installation