Mounting Precautions - Sharp AQUOS BOARD 4T-B70CT1U Guía De Configuración

MOUNTING PRECAUTIONS

• This product is for indoor use.
• Do not remove the service covers on the bottom of the product.
•
• the monitor is heavy, consult your dealer before installing, removing or moving the monitor.
•
•
•
Service
covers
• This monitor should be used at an ambient
temperature between 32°F (0°C) to
104°F (40°C). Provide enough space
around the monitor to prevent heat from
accumulating inside.
• If it is difficult to provide sufficient space for any reason such as the installation of the
monitor inside a housing or of several units side-by-side, or if the ambient temperature may
be outside of the range of 32°F (0°C) to 104°F (40°C), install a fan or take other measures
to keep the ambient temperature within the required range.
• Temperature condition may change when using the monitor together with the optional
equipments recommended by SHARP. In such cases, please check the temperature
condition specified by the optional equipments.
• Do not block any ventilation openings. If the temperature inside the monitor rises, this could
lead to a malfunction.
• Do not place the monitor on a device which generates heat.
• Do not use the product in locations where the unit is exposed to direct sunlight or other
strong light. Since this product operates with infrared rays, such light may cause a
malfunction.
• When using multiple monitors closely, be sure the infrared transmitter/receiver are not
causing interference between monitors.
be
2
[50]
- 4 -
be
below.
Unit: inch [mm]
7-7/8 [200]
1-7/16 [35]
2
[50]
2 [50]