Samsung DV45K7600EG Manual De Uso página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STEP 3 Connect the electrical wiring
First, read through the "Electrical requirements" section, and then follow these steps.
3-wire system
A
B
A. External ground connector
B. Neutral grounding wire (white)
C. Center silver-colored terminal block
screw
D. Neutral wire (white or center wire)
E. ¾" (1.9 cm) UL-listed strain relief
DV7700K-03170U-01_EN (US).indd 19
1. Loosen or remove the center terminal
block.
D
2. Connect the neutral wire (white or
C
center wire) of the power cable to the
center, silver-colored terminal screw of
the terminal block. Tighten the screws.
3. Connect the other wires to outer
terminal block screws. Tighten the
screws.
4. Tighten the strain relief screws.
5. Insert the terminal block cover into the
E
rear panel of the dryer. Then, secure the
cover with a hold-down screw.
CAUTION
• To convert from the 4-wire system
to 3-wire system, connect the ground
strap to the terminal block support to
ground the dryer frame to the neutral
conductor.
• Ring-type terminals are recommended.
If using strap terminals, make sure they
are tightened.
English 19
2015-12-29
12:08:27

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Dv45k7100egDv45k7600e(g) serieDv45k7100e(g) serie

Tabla de contenido