D-Link SHARECENTER DNS-320 Guía De Instalación Rápida página 4

Step 4:
Connect an Ethernet cable to the available Ethernet port. This cable should
connect the ShareCenter Pulse 2-Bay Network Storage to your local network
TM
via a router or switch, or directly to a computer for configuration.
Step 5:
Connect the power adapter to the power receptor.
Step 6:
Open a web browser and enter the IP address of the DNS-320 to access the
Web UI. If you have a DHCP-enabled router or server on your network, you
may need to check the DHCP table to see what IP address the DNS-320 was
assigned.
Note: The computer used to access the ShareCenter Pulse web-based configuration manager
TM
must be on the same subnet as the ShareCenter Pulse. If your network is using a DHCP server
TM
and the computer receives IP settings from the DHCP server, the ShareCenter Pulse will auto-
TM
matically be in the same subnet.
DNS-320
Router
Modem
LAN
Model: DNS-320
10/100/1000
DC IN
RESET
RESET
LAN
1 2 LAN 3 4 INTERNET USB
5V - - - 3A
Note: Please see the manual for software installation.
4
DNS-320