After Juicing; Cleaning - ADE KA 1803 Instrucciones De Operación

Cleaning

Pay attention to the following:
‚ To change the direction of rotation of the juicing cone, do not apply any pressure
on it for a moment. If you then press the fruit with a little force against the juicing
cone, the juicing cone will rotate in the opposite direction. This increases the juice
yield.
‚ The measuring scale shows the amount of juice. The maximum capacity is 750 ml.
‚ If the juice hardly flows off or does not flow off at all, the pulp strainer is clogged.
Stop juicing and remove the pulp using a teaspoon.

After juicing

1. Unplug the power cord from the mains outlet.
2. Pull off the juicing cone(s).
3. Remove the pulp strainer.
4. Pull out the juice collector.
5. Hold the glass carafe by the handle with one hand. Use the other hand to pull out
the motor block.
6. Pour the juice into a glass.
Clean the citrus juicer directly after juicing when possible. Later cleaning is
more laborious due to fructose.
Cleaning
Electrical shock HAZARD
− Do not immerse the citrus juicer and the power cord with power plug
in water or other liquids.
− Unplug the power cord from the mains outlet before cleaning the
device.
NOTE on material damage
− Do not clean the citrus juicer with hard, scratchy or abrasive cleaners,
steel wool or the like. They could scratch the surface.
1. Disassemble the citrus juicer so that all individual parts are in front of you (see also
"After juicing"). In addition, pull off the axle.
2. Clean all parts (EXCEPT the motor block!) in hot washing-up liquid or in the
dishwasher.
3. Wipe clean the motor block with housing for the juice collector with a soft, damp
cloth and some dishwashing detergent.
4. Wipe all parts dry thoroughly with a cloth.
22
KA 1803 citrus juicer