Long Term Storage:
Models 45-KFA-EU / 70T-KFA-EU:
1. Use an approved siphon to drain fuel through the
fuel cap opening.
Models 125T-KFA-EU / 175T-KFA-EU / 215T-KFA-EU:
1. Drain fuel through the drain plug in the bottom
of the fuel tank.
2. To remove the drain plug, pull the plug grip
downward and remove the seal head from the
drain hole in the tank. (See Figure 11)
Drain Plug
Figure 11
3. Using a small amount of paraffin, rinse and
swirl the paraffin inside of the fuel tank, empty
the tank fully.
4. To replace the drain plug; push the drain head
fully into the drain hole and secure by pushing
the seal cap fully into the head hole.
(See Figure 12)
Figure 12
IMPORTANT: Never store leftover paraffin between
seasons, using old fuel can damage heater.
© 2016, Obelis S.A
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE
®
Maintenance
Drain Plug Grip
(Pull Down)
Drain Plug
Fuel Tank
Seal Head
Head Flange
Seal Cap
Service:
Never service heater while it is
WARNING
plugged in or hot!
DO NOT TAMPER WITH THE UNIT. HAVE
A COMPETENT SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENT OR REPAIRS.
Use only original equipment parts. The use of
alternate or third party components can cause unsafe
operating conditions.
We suggest following a maintenance schedule as follows:
FUEL / FUEL TANK:
Flush tank every 200 hours of operation or as needed.
TIP: Follow the long term storage
instructions to flush the tank.
DO NOT flush with water, use fresh paraffin only.
AIR FILTERS:
The air intake filter should be replaced or washed
with soap and water and dried thoroughly every 500
hours of operation or less depending on conditions.
The output and lint filters should be replaced
every 500 hours of operation or less depending
on conditions.
NOTE: Use of diesel fuel may require
additional maintenance
Lint Filter
Figure 13
Kerosene Forced Air Heater User's Manual
9
Air Output Filter
Intake Filter
End Filter