Parts And Accessories; Operating Instructions - Open Country TUMBLE DRUMM TD-6065-13 Guía Del Usuario/Mantenimiento

Parts and Accessories

Hinged
Door
Bearing
Block
Water
Tub

Operating Instructions

1. Remove all packaging materials before using the first time.
2. Wash parts with soapy water and rinse. Reduce splashing and dump
dirty water by lifting Tub from Motor Drive to keep water from entering
Motor Drive area. CAUTION: ALWAYS WEAR SAFETY GLOVES
WHEN REACHING INSIDE OF DRUM!
3. Rotate Drive Coupling until slot is horizontal. Using Tub handles, lift
Drum and insert Drive Shaft into Drive Coupling. Lower the opposite
end shaft of Drum into groove on Bearing Block.
4. Place unit on level surface and add water to the "Maximum Fill Line".
Water level inside of Drum should be 1/4" to 1/2" above the bottom.
CAUTION: DO NOT POUR WATER OVER MOTOR DRIVE!
5. Release Latch by lifting and open door, place fish into Drum. For best
results load scaler by similar size and types of fish.
6. Note: TD-6065-13 (18" long drum) will scale up to 50 small panfish
and TD-6065-13L (26" long drum) is designed to scale large fis up to
22" in length.
Locking
Latch
Maximum
Fill Line
3
Drum Handle
Drive Shaft
Drive
Coupling
Motor
Drive
On/Off
switch