Abus FUMO50000 Manual De Instalación página 26

Open the housing of the Secvest wireless alarm system.
1.
Carefully lift the cover of the Secvest wireless alarm system away from the
2
base of the housing. (Fig. 01)
Power off the panel and carefully remove the ribbon cable which connects the
3
cover and the motherboard. (steps 1-3 in Fig. 02)
Lead the antenna cable from the outside through the cable openings into the
4
inside of the housing. Secure the antenna outside the housing.
Connect the GSM antenna onto the GSM module.
5
Insert the SIM card into the card holder of the GSM module.
6
The code of the SIM card must be switched off or set
to "0000". (Fig. 03)
Equip the GSM module with the supplied plastic holders.
7
Now carefully place the GSM module on the plug connectors of the
motherboard and press down firmly. Ensure that the pins do not get bent.
(Fig. 04)
Now connect the cover to the motherboard. Connect the power to the Secvest
8
again and reattach the backup battery (steps 1-3 in Fig. 05)
Place the cover on the base of the housing and tighten the locking screw.
9
(Fig. 06)
Select the required settings on the wireless alarm system in the installation
10
menu. Check that the GSM module is functioning correctly in the test menu of
the alarm system.
Disposal | Conformity
26