1.6.
Checking the coolant level
1
Check the coolant level while the engine is off and cold.
The check must be performed after placing the motor-
cycle in an upright position on a horizontal surface.
WARNING
This operation must be performed by two
people.
Ensure that the coolant level should be slightly above
the MIN mark, as shown in the figure.
If the coolant level is below the MIN mark, top up the
coolant as described at paragraph 1.6.1.
WARNING
Do not start the engine if the coolant level is
below the MIN mark.
MAINTENANCE
Coolant level
- 18 -
Min