Front Panel - imacon Flextight Precision II Manual De Instrucciones

Hardware ReferenceÑFlextight Precision II
8

Front Panel

Front Panel
Figure 1:
A Foil Holder: when you are loading originals into the reßective orig-
inal holder, roll back the clear plastic foil and insert the leading
edge in this slot.
Original Holder Clasp: all original holders slide into a slot here
B
and are held in place by a magnetic clasp.
C Reßective Original Holder Guide (Right): the A4/letter-size origi-
nal holder is held straight by two round guides.
D Power Switch: press here to turn the unit on or off.
E Power Indicator (Green): Remains lit when ready to scan. Blinks
when Þrst installed to indicate that Þrmware must be loaded (it
will be loaded automatically when you run ColorFlex).
F Zoom Indicator (Yellow): lights when the scanner is repositioning
the optics to scan in a new format
G Busy Indicator (Red): lights when scanning. If the light is blinking
when not scanning, then an error existsÑplease contact your Flex-
tight dealer for assistance.
H Transparency Holder Guide (Right): all transparency holders Þt
between two rails to keep them straight.
J Light Table: helps you to align your transparent originals
K Reßective Original Holder Support: slides out to support the large
A4/letter-size original holder.
Front panel features of Flextight Precision II
Imacon Flextight Precision II UserÕs Guide
A
A
B
C
D
E
F
G
H
J
K