Specified Use; Scope Of Supply; Device Description - Weller WD 1 Manual De Instrucciones

4-16
technical safety regulations. There is nevertheless the risk of
personal injury and damage to property if you fail to observe the
safety information set out in the accompanying booklet and the
warnings given in these instructions. Always pass on the
WD 1 (M) / WD 1000 soldering station to third parties together with
these operating instructions.
2.1

Specified use

Use the WD 1 (M) / WD 1000 soldering station exclusively for the
purpose indicated in the operating instructions of soldering and
unsoldering under the conditions specified here. Specified use of the
WD 1 (M) / WD 1000 soldering station also includes
 observing these operating instructions,
 observing all other accompanying documentation,
 observing locally applicable accident prevention regulations.
The manufacturer shall not be liable for damage resulting from
unauthorised alterations to the machine.

3 Scope of supply

Control unit
Power cable
Jack connector
Soldering iron
Safety holder
Operating
instructions
Safety information
booklet

4 Device description

The Weller WD 1 (M) / WD 1000 is a versatile soldering station for
performing professional repair work on state-of-the-art electronic
assemblies in the industrial engineering sector as well as repair
workshops and laboratories.
Precise temperature control performance at the soldering tip is
guaranteed by the digital control electrotechnology together with
superior-quality sensor and heat-transfer technology. High-speed
measured-value acquisition provides for maximum temperature
precision and optimum dynamic temperature performance in load
situations.
All soldering irons (except for microtools) up to 80 Watts can be
connected to the WD 1. The temperature range is from 50 °C to
450 °C (150 °F to 850 °F). The WD 1M is multifunctional and all
soldering irons up to 150 Watts and microtools (WMRP & WMRT)
can be connected; the temperature range is from 50 °C to 450 °C
(150 °F to 850 °F). Setpoint and actual values are displayed in digital
from. Three temperature buttons are used to select fixed
temperatures directly.
WD 1 (M) / WD 1000
WD 1 WD 1000 WD 1M
 
 
 




 
 






