The Remote Control System; Charging The Battery - XciteRC EAGLE one16 Manual De Intrucciones

The remote control system

Here you get an overview of the remote control system of your Eagle One16 and its various features and
settings. Before the first flight, you should have read and understood all these functions and settings.
EN
• Make sure that the transmitter is turned off - ON / OFF switch in position O.
• Now open the battery compartment cover on the bot-
tom of the transmitter and insert two AA batteries (or
rechargeable batteries) into the battery compartment of
the transmitter. Pay attention to the correct polarity!
• Close the battery compartment cover and turn on trans-
mitter – push ON / OFF switch in position I - the red
transmitter POWER-LED starts flashing.
• Now switch on the model, the red LED must lit.
• WARNING: If the LED still flashes or goes out, the
model may not be started, because there is no binding to the model or the transmitter batteries are empty
– crash hazard! Change transmitter batteries immediately.
• Pay attention to the LED also during operation. If the LED flashes, stop driving as soon as possible and
replace transmitter batteries (or recharge the batteries).

Charging the battery:

Before the first use of your new model the drive battery needs to be charged with the included USB-charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
For charging remove the battery from the vehicle.
WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
• Insert the USB connector of the charger in a suitable USB socket, for example your PC. The green LED
lights up.
• Now connect the white balancer connector of drive battery to the jack of the Micro-Charger.
NING: the connector is polarized, note the bumps. The connector must engage with slight pressure, you
not use any force - fire hazard!
• If the battery is connected with the Micro-Charger, the LED changes from green to red, which indicates
that the battery is charged. The charging time is approx. 1.5 hours.
• The green LED indicates the end of the charging process, disconnect the battery from the charger.
• Unplug the AC adapter.
18
The remote control system · Charging the battery
1
USB
LED
5 V DC
2
-
+
WAR-
Eagle One16