Product Disassembly - Easy Home 14664 Instrucciones De Montaje

5. Press the push buttons
vertical extenders into the vertical bars (see Fig. E).
The ends with the push buttons should go inside the vertical bars. Lock the
vertical extenders in place by letting the push buttons pop out from one of
the holes on the vertical bars. Make sure that both vertical extenders are
locked in place at the same height.
6. Attach the T-connectors
(see step 1 in Fig. F).
7. Attach the end caps
(see step 2 in Fig. F).
8. Insert the other end of the horizontal extenders into the upper hanging bar
through the T-connectors (see step 3 in Fig. F).
Flip up the locking levers on the T-connectors before inserting the
horizontal extenders. Clamp down the levers to lock the horizontal
extenders in place.
9. Attach the T-connectors (with the upper hanging bar) to the top of the
vertical extenders (see Fig. G).
You have successfully assembled the product.
− Use the castors to move the product to the desired indoor
− To adjust the height of the upper hanging bar:
− To adjust the length of the horizontal extenders:

Product disassembly

Reverse the steps in the chapter "Product assembly" to disassemble the
product.
12 on the vertical extenders
8 to the two ends of the upper hanging bar
9 to one end of the horizontal extenders
location. Engage the locking levers of the swivel brake castors
to lock the product in place.
Disengage the locking levers on the T-connectors, press
the push buttons down and then raise or lower the vertical
extenders. Make sure the push buttons pop out from one of
the holes on the vertical bars and engage the levers again to
lock the extenders in place (see step 1 in Fig. H).
Disengage the locking levers on the T-connectors and slide
the extenders inwards or outwards. Make sure the levers are
engaged again to lock the extenders in place (see step 2 in
Fig. H).
Product disassembly
2 and insert the
6
1
11