Zennio IDAC Manual De Instalación página 14

ELECTRONIC MODULES ASSEMBLY
1. External electronic
module (1x)
2. 15-pin interconnection
cable (1x)
1
* Rear view
1
Connect the module interconnection cable (15 pins) to the
external electronic module. Place the external module in its
position, passing its cable through the door hole. Place the fixing
plate near the internal part of the door and pass the
interconnection cable and the electric lock cable though the plate
hole. The plate must be oriented with the threated-hole for the
security screw facing downwards.
* Note: Images show the assembly for a left-hand door. For right-hand doors the assembly is symmetrical.
(See https://www.zennio.com/download/idac_technical_note_door_direction_din_107_en for left-hand/right-
hand description).
© Zennio Avance y Tecnología S.L.
Electronic module parts
2
* External view
Ed. 3
3
* Internal view
2
Cut the through-screws to adapt their length to the door thickness and
use them to tighten the fixing plate to the external electronic module
previously inserted into the door.
Further info: www.zennio.com
3. Electric lock cable
4. Fixing plate (1x)
5. Through-screws (4x)
6. Internal electronic module (1x)
7. Security screw (1x)
4
5
6
7
(5)
(5) Threaded through-screw
M4 x 90 - countersunk
(7)
(7) Security screw
M2.5 x 4 - Torx
1x
4x
Page 6 / 8