meireles MLR 1491 W Manual Del Usuario página 53

To realize quieter operation, a bottom cover is supplied with the unit (only applies
to some of the Hisense washers). After installing the cover at the bottom of the
washer, the noise level will be greatly reduced. Please ask for advice from
specialists before installing the cover, nevertheless, the machine can be used
without the bottom cover.
Noise-Reduction Bottom Plate Installation Instructions
8
A:
Stick acoustic ool to the side of bottom cover plate
ith the letter of "PUMP".
Tilt the asher by 30 -40 , hen installing the bottom
cover, please face the side ith sound insulation
up ards and attach PUMP at the corner of the cover
to the position of the pump in the asher.
Before installing the noise-reduction bottom
B:
plate, align and paste the acoustic absorption
on bottom plate (this procedure is unnecessary
for some of the models
absorption ool).
Incline the machine to an angle of 40 and let
the side
front of the
figure. Insert the side
bet een t o foot scre s at back of the
Pump
install the bottom plate and ensure that it
contacts
closely.
9
If the ater inlet hose is not already installed, it must be
scre ed to the appliance.The blue marked hose is only
for cold ater. Depending on the model, the hot
aterhose marked ith red should also be connected,
for models having dual inlets.
10
23
INSTALL BOTTOM COVER
ool ith and along the right-angle impression
ith right-angle notch face to ards
ashing machine, as sho n in the
ith oblique-angle notch
ashing machine completely in place. Then,
ith bottom of the
PUMP
ithout acoustic
Double sided tape
ashing machine
PUMP
Remove surface paper on
double sided tape at four sides
of the bottom plate.
Press the double sided tape
on four sides manually to
secure the noise-reduction
palte to the machine body
firmly.