Safety Precautions - König Electronic KN-CL40 Manual De Uso

- In normal mode, press the "CH/UP" key for 2 seconds to clear the display data of the current RF
channels and renew the channel data.
- If the same ID code to make an effective signal is not received within 60 minutes ,the booked CH
temperature will show "--.-".and into RF long receiving for 3 minutes, if it received the same ID code
effective signal within 3 minutes, and it will exit RF receiving mode and revert to normal mode; If the
same ID code effective signal it still not received within 3 minutes it will exit the RF receiving mode
and wait for the next hour and will then go into the RF long receiving mode again, then will keep on
cycling until the signal is received or reset.
- During RF receiving, the antenna icon starts to flash at the 2 Hz frequency and it will keep the icon on
screen if it received the temperature signal. If no temperature signal is received, the icon will
disappear.
- The cycle time for the different channels are: CH1 – 57 secs, CH2 – 67 secs, CH3 – 79 secs.
When the RF is synchronized, the max. time needed to make contact is 3 seconds.
Wireless remote sensor (transmitter) instructions
- Transmitter frequency: 433.92 MHz.
- Batteries: 2 x 1.5 V AAA.
- Use a screw driver to remove the back battery compartment cover. Insert the 2 batteries into the
transmitter according to the correct polarity.
- Press the "°C/°F" button to select the temperature, either in °C or °F.
- You can put the transmitter in a garage, on an outdoor, window, on an indoor living room wall or in
the garden.
- The valid distance for the transmitter and receiver to work is up to 30 m (100 feet) in an open area.

Safety precautions:

Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3