Fault Finding - Atco-Qualcast CLASSIC ELECTRIC 30 Instrucciones De Operación

GB • Printed in England • BA F 016 L69 839 • QX elctric • OSW 02.02
F016 L69 839.book Seite 6 Freitag, 22. Februar 2002 10:04 10
The following table gives checks and actions that you can perform if your machine does not oper-
ate correctly. If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Symptom
Machine fails to oper-
ate
Machine functions
intermittently
Machine labours or
belt squeals
Machine leaves rag-
ged finish
Cutting blades not
rotating
Land drive does not
engage (self pro-
pelled models only)
Excessive vibration/
noise
Poor collection
18 • F016 L69 839 • TMS • 05.02.02

Fault Finding

Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Extension cable damaged
Machines internal wiring damaged
Height of cut too low
Blades off cut
Cutting blade(s) blunt
Blades off cut
Cutting blades obstructed
Belt is slipping or is damaged
Incorrect adjustment
Cable damage
Cutting blades damaged
Cutting blades not adjusted evenly
Mowing in wet conditions
English
Remedy
Turn power on
Use another socket
Inspect cable, replace if dam-
aged
Replace fuse
Inspect cable, replace if dam-
aged
Contact Service Agent
Increase height of cut (see "Height
of Cut Adjustment")
Adjust blades
Contact Service Agent
Adjust blades
Clear obstruction
Contact Service Agent
Adjust cable
Contact an ATCO-QUALCAST
Approved Service Agent
Contact Service Agent
Adjust blades
Allow grass to dry
- 6