2/ Mockup Installation - Swiftech H20-120 COMPACT Guia De Instalacion

Install the fan using the provided screws and
fasten the screws with the provided retaining
nylon washer to hold them in place.
Attach the tubes to the Apogee™ Drive fittings and clamp them as shown. The clamps should
always be completely closed to provide a proper seal.

2/ MOCKUP INSTALLATION

It is necessary to temporarily position the elements of the kit in the case in order to evaluate the
appropriate length of tubing needed between components. Fully tightening the screws will not be
necessary for this step.
Fasten the screws just enough to hold the
radiator in place.
TIP: How to decide in what direction the fan
should blow?
OUT TO IN (fan label facing in as shown in the
example):
Pros: Much lower CPU temperature.
Cons: Potentially more heat inside the case
(OK if good case ventilation), dust will collect
on radiator & fan and require more frequent
maintenance.
IN TO OUT (fan label facing out):
Pros: Lower case temperature (this setup is a
must in poorly ventilated systems), lower
maintenance (regular dust filter cleaning is still
required),
Cons: Higher CPU temps
Fasten the screws just enough to hold the
Apogee™ Drive in place.
Page 2