Tabla De Contenido; Tools Needed For Assembly - PRG UNV Manual De Instalación, Funcionamiento Y Servicio

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Note: Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum Load Capacity. See page 1.
• If mounting to wood ceiling studs, make sure that mounting screws are anchored into the center of the studs. Use of
an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1 800 865-2112.
• This product was designed to be installed on the following ceiling construction only;
CEILING CONSTRUCTION
x
Wood Stud
x
Wood Beam
x
Solid Concrete
Cinder Block
Metal Stud
Brick
Other or unsure?

Tools Needed for Assembly

• stud finder ("edge to edge" stud finder is recommended)
• phillips screwdriver
• drill
Table of Contents
Parts List .......................................................................................................................................................................... 3
Installation to Extension Columns / Ceiling Plate .............................................................................................................. 4
Installation to Wood Joist Ceilings .................................................................................................................................... 5
Installation to Concrete Ceilings ........................................................................................................................................ 6
Installation to Threaded Rods ............................................................................................................................................ 7
Attaching Adapter Plate to Projector ................................................................................................................................. 8
Cable Management ......................................................................................................................................................... 10
Projector Alignment ........................................................................................................................................................ 11
Accessories .............................................................................................................................................................. 12, 13
WARNING
ADDITIONAL HARDWARE REQUIRED
None
None
None
Contact Customer Service
Contact Customer Service
Contact Customer Service
Contact Customer Service
• 1/4" bit for concrete surface
• 5/32" bit for wood studs
• open end wrench
• level

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Unv-sUnv-w

Tabla de contenido