Accessories; Maintenance - AGREX SP Serie Instrucciones Para El Uso Y La Manutención

SP
LOADING
Before loading the hopper the self-propelled vehicle or tractor must be switched off
and the parking brake applied. It is advisable for the same operator to load the
hopper after having switched off the tractor motor.
Everytime the spreader has to be filled up it is advisable to check that there arn't any foreign particles on
the bottom that may obstruct the shutter.
REGULATING THE QUANTITY SUPPLIED
The quantity of product scattered can be increased or decreased by means of the opening lever. The
quantity is increasd by pushing the lever downwards and decreased by pulling it upwards, until the
supply is shut off. (Fig.7 pag.31)
DISC WITH ADJUSTABLE BLADES
According to the specific weight of the fertilizer to be spread, it is possible to direct the blades by moving
them in the special clamps from N° 1 to N° 5, to obtain even scattering to the right and left. The blades
are normally in position N° 3. By moving the blades towards N° 1 the scattering range to the left of the
driver is increased. By moving them towards clamp N° 5 the scattering range to the right of the driver
is increased. (Fig.8 pag.31)
9

- ACCESSORIES

The fertilizer spreader can be equipped with the following accessories:
MANUAL TOWING KIT
This accessory allows the fertilizer spreader to be easily manoeuvred once it has been detached from the
tractor. (Fig.9 pag.31)
SALT AND SAND SPREADER CONE
This is composed of a steel cone section with two adjustable side supports which hook onto the frame. By
varying the height of the cone the scattering range is regulated, making it possible to scatter the product
over the area beneath the hopper. (Fig.10 pag.31)
MECHANIC REMOTE CONTROL
For the regulation of the spread of the product from the drivers seat of the tractor.(Fig.11 pag.31)
10

- MAINTENANCE

All maintenance operations must be carried out by skilled personnel strictly adhering
to the instructions given in this booklet.
For efficient maintenance: disconect the spreader from the tractor , clean the working area and use suitable
utensils suitable to the type of work that the spreader is used for.
At the end of the maintenance routine, check and reposition all safety devices
and the covers protecting them.
22
USER'S GUIDE
ENGLISH