Loading Your Software; Establish Communication To The Processor - Rockwell Automation Allen-Bradley SLC 5/03 Instrucciones De Instalación

8 SLC 5/03, SLC 5/04, and SLC 5/05 Modular Processors
Power Supply and LED Indicators
POWER RUN
FLT
BATT
POWER RUN
FLT
BATT

Loading Your Software

Refer to your programming software documentation.

Establish Communication to the Processor

1. Refer to the following table to establish communication between the
processor and your personal computer.
Processor Procedure
SLC 5/03 Connect the 1747-PIC interface from the processor to your personal computer serial port
or connect the 1747-UIC interface from the processor to your personal computer USB
port to the processor using the 1747-C13 or 1747-CP3 cable. You can also use a
1784-PKTX(D) or 1784-PCMK interface, or a 1747-CP3 cable from channel 0 of the
processor to the personal computer serial port.
SLC 5/04 Connect a 1747-CP3 cable from channel 0 of the processor to the personal computer
serial port or connect the 1747-UIC interface from channel 0 of the processor to your
personal computer USB port, or use a 1784-PKTX(D) or 1784-PCMK interface.
SLC 5/05 Connect a 1747-CP3 cable from channel 0 of the processor to the personal computer
serial port, or connect the 1747-UIC interface converter from channel 0 of the processor
to your personal computer USB port. For Ethernet connection, connect channel 1 of the
processor and the PC Ethernet Card to an Ethernet hub using 10/100Base-T compatible
cable.
(1)
EtherNet/IP address must first be set via BOOTP or an RS-232 connection.
Publication 1747-IN009E-MU-P - April 2007
FORCE
DH485
RS232
SLC 5/03
FORCE
DH+
RS232
SLC 5/04
(1)
Indicates the LED indicator is OFF.
Indicates the LED indicator is ON.
Indicates the LED indicator is FLASHING.
Status of LED indicator does not matter.
POWER RUN FORCE
FLT ENET
BATT RS232
SLC 5/05