Adjusting Depth Of Cut - EGO EA0800 Manual Del Operador

WARNING:
obstacles and solid objects from the work
area.
Hold the edger with your right hand on the
rear handle and your left hand on the front-
assist handle. Keep a firm grip with both
hands while operating the tool. The edger
should be held at a comfortable position
with the rear handle at about hip height
(Fig. 3).

ADJUSTING DEPTH OF CUT

1. Stop the motor and remove the
battery pack.
2. Loosen the depth-adjusting knob in
the direction of the unlocking arrow
marked on the knob (Fig.4).
3. Move the guide wheel, along the
depth-adjusting guide bar, up to
increase the depth of cut or down to
decrease the depth (Fig. 5).
The depth of cut depends on the
unevenness of the ground, your height
and the way you hold the edger. Use the
following procedures:
Clear away all
3
4
Depth-adjusting Knob
5
To Increase Depth
To Decrease Depth
Depth-adjusting Guide Bar
EDGER ATTACHMENT—EA0800
15