Setting Light Time (Time); Adjusting Sensor Sensitivity (Sens); Adjusting Light Sensitivity (Lux); Cleaning / Maintenance - Targa LSHB 150 B1 Manual Del Usuario E Información De Servicio

 To align the motion sensor (8) vertically, you must first loosen the
locking screw (6). If the motion sensor (8) is located in the desired
position, you must tighten the locking screw (6) again.

8.2. Setting light time (TIME)

You use the TIME control (15) at the bottom of the motion sensor (8) to set
the light time (approx. 10 seconds to 12 minutes). Turn the TIME control
(15) clockwise (+ direction) to increase the light time or anti-clockwise (-
direction) to reduce the light time.

8.3. Adjusting sensor sensitivity (SENS)

You use the SENS control (14) at the bottom of the motion sensor (8) to
adjust the sensor sensitivity. Turn the SENS control (14) clockwise (+
direction) to increase the sensitivity or anti-clockwise (- direction) to reduce
the sensitivity. The higher the sensitivity, the greater the detection range
(12 metres at the most).

8.4. Adjusting light sensitivity (LUX)

You use the LUX control (13) at the bottom of the motion sensor (8) to
adjust the light sensitivity. Here, you set the lighting conditions to which the
twilight sensor responds and thus the outdoor halogen spotlight is switched
on or off.
Turn the LUX control (13) clockwise (
sensor (8) responds to brighter lighting conditions.
Turn the LUX control (13) anti-clockwise (
sensor (8) responds to darker lighting conditions.

9. Cleaning / maintenance

Maintenance
The outdoor halogen spotlight does not contain any parts that require
maintenance.
LIVARNO LUX LSHB 150 B1

direction) so that the motion

direction) so that the motion
English - 31