Garmin ecoRoute Manual Del Usuario página 6

2. Turn on the GPS device.
3. Bring the GPS device within 10
meters (33 feet) of the ecoRoute HD
device.
4. From the Tools menu, touch
ecoRoute.
5. If necessary, follow the on-screen
instructions to set up ecoRoute.
6. From the ecoRoute menu, touch HD
Connection.
7. Follow the on-screen instructions
to connect the ecoRoute HD device
with the GPS device.
The LED turns blue when the
ecoRoute HD device is connected to
your GPS device.
8. Turn the vehicle off and then back
on to save the setup information.
After the initial connection, the
ecoRoute HD device will automatically
connect to the GPS device when they
are turned on and are within 10 meters
(33 feet) of each other.
Note: When the ecoRoute HD is
not connected with a GPS device, the
ecoRoute HD device records the vehicle
information and sends the data to the
GPS device the next time they connect.
turning on ecoRoute Without
Starting Your Car
On some vehicles you can only reset
error codes if the engine is off and the
key is in the on position.
1. Turn the ignition switch to the on
position. Do not turn on the engine.
2. Press and release Reset.
About the LEDs
The two LEDs, green and blue, on the
top of the ecoRoute HD device indicate
the connection status.
LED
Three green
flashes
Slow Green
flashing
Green solid
6
Meaning
Establishing a connection
with vehicle and GPS
device. Setup mode.
Connecting to the vehicle.
Communicating with the
vehicle.