Possible Values For Each Parameter; Session Time; Quick Start - Kinetec Spectra XL Manual De Empleo

9.4. Possible values for each parameter

• Treatment mode
• Extension limit
• Flexion limit
• Speed
• Force
• Extension Pause
• Flexion pause
• Timer
• Number of Programs

9.5. Session Time

This function shows the running time (in minutes) of the session (motor functioning).
It is directly accessible by the key
This counter is reset each time the unit is switched ON.

9.6. Quick Start

The device Kinetec Spectra XL™ continuously records the session data (only if the USB key is
connected).
Set up the patient and proceed as below:
Beginning
Switch the unit on
Starting the session with the parameters from
the previous session, unless you are using a
daily program (see the instruction manual for
the Kinetec Data Capture™ software).
When the USB bar is connected the symbol "usb" is displayed in the upper right of the display.
Warning: Always check the motion parameters displayed on the hand control before starting
the device.
Kinetec Spectra XL™
Possible values
-10 to 115°
-5° to 120°
1 to 5 (from 45° to 155° per
minute)
1 to 6
0 to 900 seconds (15 minutes)
0 to 900 seconds (15 minutes)
No timer (00H00) to 24H00
16
, the display shows TIME
Keys to
Display
press
KINETEC
Spectra Vxx.x
Movement Verify.
Please Wait
Hello
Patient's first name
KINETEC
30 STOP
Warm up
30 STOP
KINETEC
30 RUN
EN
Default setting
Normal
30°
70°
2
6
0
0
0
Empty
02H35
usb
Displays the last movement used,
35 70 except for the daily program.
usb
Check if the hand control is not
35 70
locked (See page 7).
usb
The angle display changes with the
45 70
current movement
Remarks
.
8/20