Icons; Standard Equipment; Machine Assembly; Engine Oil - RIDGID KJ-2200 Manual De Instrucciones

Icons

Standard Equipment

All Jetters come with
• Appropriate Jetter Nozzles
• Nozzle Cleaning Tool
• FV-1 Foot Valve
• Engine Operator's Manual
See the RIDGID catalog for specific equipment sup-
plied with each catalog number.
NOTICE This machine is made to clean drains. If prop-
erly used it will not damage a drain that is in good con-
dition and properly designed, constructed and
maintained. If the drain is in poor condition or not prop-
erly designed, constructed or maintained, the drain
cleaning process may not be effective or could cause
damage to the drain. The best way to determine the con-
dition of a drain before cleaning is through visual in-
spection with a camera. Improper use of this jetting
machine can damage the jetter and the drain. This ma-
chine may not clear all blockages.

Machine Assembly

To prevent serious injury during use and prevent
machine damage, follow these procedures for proper
assembly.

Engine Oil

Jetter is shipped without oil in the engine.
NOTICE
Operating the engine without oil will result in engine
failure. Add oil prior to operation. See supplied engine
operator's manual for specific information on adding oil
and oil selection.

Pump/Gearbox Oil

Pump: Replace the plug in the top of the pump and re-
place with dipstick/breather cap. Operating the jetter
with the plug in place could damage the pump seals.
Check oil level per Maintenance Instruction section.
Gearbox (KJ-3100 only): Replace the plug in the top of
the pump with dipstick/breather cap. Oper ating the jetter
with the plug in place could damage the gearbox seals.
Check lubricant level per the Maintenance Instruction
section.
Find Quality Products Online at:
Pressure Mode
Pulse Mode
WARNING
GlobalTestSupply
www.
KJ-2200/KJ-3100 Water Jetting Machines
Outer
Grove
Retaining
Clip
Figure 4 – Assembly of the KJ-2200
KJ-2200 Transport Cart
1. Install retaining clip into inner groove on each end of
axle. (See Figure 4.)
2. Slide a wheel over each end of axle.
3. Install retaining clip into outer groove on each end of
axle to retain wheel.
4. Use the supplied carriage bolts and wing nuts to at-
tach the handle to the frame.
5. Lift the motor/pump assembly onto the cart, aligning
the holes in the base plate with the pins in the top of
the cart. Use the latches on the cart to retain the
motor/pump. Make sure the assembly is securely
attached.

KJ-3100 Handle Assembly

1. Insert handle through the two holes in the rear cross
bar of the frame. (See Figure 5.)
2. Insert a hairpin through the holes at the bottom of the
handle to prevent the handle from pulling out.
3. Screw the T-knobs into the rear cross bar. Adjust
the handles as desired and tighten the knobs to se-
cure the handle.
.com
sales@GlobalTestSupply.com
5