Tool Specifications; Tool Setup - Bostitch MFN-201 Manual De Operación Y De Mantenimiento

MFN-201 TOOL SPECIFICATIONS
All dimensions in inches unless otherwise specified
Description
Fastener Type
Magazine Capacity
Length
Width
Height
Weight
MFN-201 FASTENER SPECIFICATIONS
Tool Model
MFN-201 Manual
Flooring Nailer
NOTE:
BOSTITCH tools have been engineered to provide superior customer satisfaction and are
designed to achieve maximum performance when used with precision BOSTITCH fasteners
engineered to the same exacting standards. BOSTITCH cannot assume responsibility for
product performance if our tools are used with fasteners or accessories not meeting the
specific requirements established for genuine BOSTITCH fasteners and accessories.

TOOL SETUP

The MFN-201 was designed to install 1/2" to 3/4" tongue and groove hardwood flooring. The tool is factory set for
3/4" flooring. Two additional foot plates are included with this tool to accommodate 1/2" and 5/8" flooring.
Flooring products will vary and the user must ensure the tool is properly adjusted each time
flooring is being installed. Dimensions listed on the footplates are suggestions. Test fastener
placement on scrap pieces of wood before installing floor.
To change footplates:
1. Remove 4 flat head cap screws.
2. Change to desired plate.
3. Replace 4 flat head cap screws.
FASTENER PLACEMENT:
Too High
MFN-201
Manual Flooring Nailer
"L " Type 16 Gauge Flooring Cleats
120 cleats
13-7/16" (340mm)
3-1/2" (89mm)
17-1/2" (444mm)
8.6 lbs (3.9kg)
Fastener Type Fastener SKU
FLN-150
FLN-200
Correct
4
Gauge
16
16
Flat head
cap screws
Too Low
Length
1-1/2"
2"