Tool Specifications - Bostitch IC60-1 Manual De Operación Y Mantenimiento

IC60-1 TOOL SPECIFICATIONS
All screws and nuts are metric.
MODEL TOOL
OPERATION
IC60-1 Contact Trip
FASTENER SPECIFICATIONS:
This tool uses a wide range of nail sizes in lengths of 1" to 2-3/8" (25 - 60mm) and shank diameters of .080"
to .090" (2.0 - 2.3mm)
TOOL AIR FITTING:
This tool uses a 1/4-18 N.P.T. male plug. The inside diameter should be .200" (5mm) or larger. The fitting
must be capable of discharging tool air pressure when disconnected from the air supply.
OPERATING PRESSURE:
70 to 100 p.s.i.g. (4.9 to 7.0 kg/cm2). Select the operating pressure within this range for best fastener
performance. DO NOT EXCEED THIS RECOMMENDED OPERATING PRESSURE.
AIR CONSUMPTION:
The IC60-1 requires 3.6 cubic feet per minute of free air to operate at the rate of 100 nails per minute, at 80
p.s.i.g. (5.6 kg/cm ). Take the actual rate at which the tool will be run to determine the amount of air required.
2
For instance, if your fastener usage averages 50 nails per minute, you need 50% of the 3.6 c.f.m. which is
required for running at 100 nails per minute.
OPERATION
BOSTITCH OFFERS TWO TYPES OF OPERATION FOR THIS SERIES TOOL
CONTACT TRIP:
The common operating procedure on "Contact Trip" tools is for the operator to contact the work to actuate
the trip mechanism while keeping the trigger pulled, thus driving a fastener each time the work is contacted.
This will allow rapid fastener placement on many jobs, such as sheathing, decking and pallet assembly. All
pneumatic tools are subject to recoil when driving fasteners. The tool may bounce, releasing the trip, and if
unintentionally allowed to recontact the work surface with the trigger still actuated (finger still holding trigger
pulled) an unwanted second fastener will be driven.
SEQUENTIAL TRIP:
The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This
makes accurate fastener placement easier, for instance on framing, toe nailing and crating applications. The
Sequential Trip allows exact fastener location without the possibility of driving a second fastener on recoil, as
described under "Contact Trip". The Sequential Trip Tool has a positive safety advantage because it will not
accidentally drive a fastener if the tool is contacted against the work – or anything else – while the operator is
holding the trigger pulled.
MODEL IDENTIFICATION:
Refer to Operation Instructions on page 7 before proceeding to use this tool.
CONTACT TRIP
Identified by:
BLACK TRIGGER
All manuals and user guides at all-guides.com
LENGTH HEIGHT
(10-5/8") 270mm (11") 280mm
SEQUENTIAL TRIP
Identified by:
GRAY TRIGGER
-4-
WIDTH WEIGHT
(5-1/4") 133mm (5.7lb.) 10oz. 2.85kgs.