D-Link DWR-953 Guia De Instalacion página 5

Ocultar thumbs Ver también para DWR-953:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
TROUBLESHOOTING
SETUP AND CONFIGURATION PROBLEMS
1.
HOW DO I CONFIGURE MY DWR-953 ROUTER OR CHECK MY WIRELESS NETWORK NAME (SSID)
AND WIRELESS ENCRYPTION KEY?
• Connect your PC to the router using an Ethernet cable.
• Open a web browser and enter the router's IP address: http://192.168.0.1
• Log into the router using the default username admin; leave the password area blank.
• Once logged in, you can use the wizard located under Internet settings to configure the router,
or make changes manually.
Note: If you have changed the password and cannot remember it, you will need to reset the
router to factory defaults.
2.
HOW DO I RESET MY DWR-953 ROUTER TO FACTORY DEFAULT SETTINGS?
• If you cannot remember your router administrator password, you may use a paperclip to press
and hold the reset button on the front of the router for about 10 seconds.
Note: Resetting the router to factory default will erase the current configuration. To reconfigure
your router, log in as outlined in question 1, then run the Setup Wizard.
3.
HOW DO I ADD A NEW WIRELESS DEVICE OR PC IF I HAVE FORGOTTEN MY WIRELESS
NETWORK NAME (SSID) OR WIRELESS ENCRYPTION KEY?
• Every device that needs to connect to the router wirelessly will need use the correct Wireless
Network Name (SSID) and encryption key.
• Use the web-based user interface (as described in question 1 above) to check or choose your
wireless settings.
• Make sure you write down these settings so that you can enter them into each wirelessly-
connected PC. You will find a dedicated area on the back of this document to note this important
information down for future use.
4.
WHY AM I UNABLE TO ESTABLISH AN INTERNET CONNECTION?
• If connecting using a 4G mobile connection, make sure that you are within range of the mobile
service provider, and that the service has been correctly configured.
• If connecting using the WAN via ADSL/Cable service, make sure the modem has been enabled/
connected and is operational, and that the service is correctly configured.
TECHNICAL SUPPORT
DWR-953
dlink.com/support
3

Publicidad

Tabla de contenido
loading

Tabla de contenido