Nevir NVR-831 TBTU Manual De Instrucciones página 20

(3) Setting up bluetooth pairing:
Initial pairing:
1. Switch on the tower speaker. Press the SOURCE button and select
Bluetooth mode
2. Bluetooth blue LCD light will blink non-stop in searching for device.
3. When a device is found, it will show the name "NVR-831 TBTU".
Just enter password "0000" to connect or pair with the tower speaker.
Re-pairing:
4. Switch on the tower speaker. Press the SOURCE button and select
Bluetooth mode.
5. Bluetooth blue LCD light will blink 3 seconds and it is automatically finding
the last device it was paired with. When the device is found, it can play
backdirectly.
6. If there is no device found, the bluetooth LCD light will continue to
blinknon-stop. Enter password to start with or press SOURCE button to
select FM, AUX in, LINE in or USB.
(Bluetooth SET UP) NOTE:
1. The Bluetooth speaker only connects to device at a time. Turn off the
Bluetooth speaker in order to pair the device with another Bluetooth device.
2. The maximum transmission between the Bluetooth speaker and a deviceis
10 meters or 32 feet.
3. Interferece may occur during playback when using the Bluetooth
function near other wireless devices. If playback through Bluetooth is
problematic,move the Bluetooth speaker and the playback device to a
different location, or use the 3.5mm audio cable jack instead of the
Bluetooth function.
(4) Listening and setting up FM radio
FM Antenna
Adjust the FM Wire Antenna (included) to get the best reception signal.
Tuning the FM Radio
1 Press the POWER button to turn the tower speaker on.
2 Press the SOURCE button to switch to FM radio mode.
3 Press the TUN+/CLOCK+ or TUN-/CLOCK-buttons on the remote to tune
the FM radio.
Listening to a Saved Radio Station
1 Press the POWER button to turn the tower speaker on.
2 Press the SOURCE button to switch to FM radio mode.
3 Press the TUN/MEM buttons on the remote control to cycle through saved
radio stations.
20