Troubleshooting - PNI TV901 Manual Del Usuario

EN
6. System settings
• Parental guidance
• Set password , the default password is "000000"
• Restore factory default
• Info
• Software update
7. USB settings
• Multimedia
• Photo configure
• Movie configure
• PVR configure
USING INSTRUCTIONS
View TV channels
After searching the free distributed TV channels in your area you can use the following quick commands on the remote:
Press OK button to access TV channel list
Press EPG button to view TV guide (if available from the TV channel)
Play files from a USB memory / external HDD
The device can be used as a multimedia player also. The supported files are:
• Photo: JPEG / BMP / PNG
• Audio: MP3 / AAC
• Video: AVI / MPG / DAT / VOB / MKV / MJPEG
TV program recording
This function allows you to record and view your favorite programs anytime.
NOTE: To use this function you need a USB memory or external HDD connected to the device.
• Instant recording: press
upper right corner of the screen. Press INFO button to view recording information. Press
• Timer recording: press EPG button to access TV electronic guide. Select desired channel then press OK button. On
the screen will appear a new window where you can select the recording parameters. This way, the selected program
will be recorded in the time you selected. You can always change recording parameters by pressing the Green button
or delete the recording by pressing the Blue one on the remote. After you finish setting the recording, press EXIT button
to save an close menu.
• Timeshift function: if you have to leave for a little while but don't want to miss the current program, this function allows
you to temporary record the program to view it when you return. To activate this function press
program you are viewing. When you come back press
function press button.
If you want to view your recordings access the USB memory and choose PVR option.
NOTE: Timeshift functions does not work with 1.8 inch HDDs.
IMPORTANT: The record functions can be used only when the device is ON.

TROUBLESHOOTING

Problem
The device is connect but there is
nothing on the screen
The TV image is gone and replaced
with the message "No signal"
The remote is not working
button to start recording the current program. The recording symbol will be shown in the
Possible cause
The device is not ON
The antenna is not connected properly
or you have the device in a low signal
area
The batteries are low or there are
obstacles between the remote and
device
6
button to replay the program you missed. To deactivate the
Solution
Turn on the device with the remote
- Check antenna connection
- Move antenna in another area
Replace batteries, make sure that
sunlight does not hit the remote or the
device directly and that there are no
obstacles between the remote and the
device
button so stop recording.
button to stop the