Replace The Base Grille; Start The Icemaker - General Electric Side by Side 23 Manual Del Propietario E Instalación

Installation Instructions
INSTALLING THE REFRIGERATOR
(CONT.)
[] REPLACE THE BASE GRILLE
Replace the grille by installing the two
Phillips head screws.
[] START THE ICEMAKER
Set the icemaker power switch to the
I (on) position. The icemaker will not
begin to operate until it reaches its
operating temperature of 15°F (-9°C)
or below. It will then begin operation
automatically. It will take 2-3 days to
fill the ice bin.
NOTE:
In lower water pressure conditions, the
water valve may turn on up to 3 times
to deliver enough water to the icemaker.
[] SET THE CONTROLS
Set the controls to the recommended
setting.
5 5
[.EOOMME.OEO CO.T.O'SE ..OS]
0 *F IS RECOMMENDED 37 *F IS RECOMMENDED
24