Resetting To Factory Default Settings; Further Information - Axis 215 PTZ-E Installation Guide

Page 12

Resetting to factory default settings

This will reset all parameters, including the IP address, to the factory default settings:
1. Remove the dome and the black ring by loosening the 4 screws for the dome, and unscrewing
the 4 screws for the black ring.
2. Disconnect power from the camera by removing the power connector.
3. Press and hold the Control button and
reconnect the power connector.
4. Keep the Control button pressed until
the Status indicator displays amber (this
may take up to 15 seconds), then release
the button.
5. When the Status indicator displays green
(which can take up to 1 minute) the
process is complete and the camera has
been reset.
6. Re-assign the IP address, using one of
the methods described in this document.
It is also possible to reset parameters to the original factory default settings via the web interface.
For more information, please see the online help or the user's manual.

Further information

The user's manual is available from the Axis Web site at www.axis.com or from the Axis Network
Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your
AXIS 215 PTZ-E. To see the currently installed firmware version, see the Basic Configuration
web page in the product's Setup tools.
AXIS 215 PTZ-E Installation Guide
power connector
control button