Installation Instructions; Unpacking Instructions; Prepare Microwave Oven - Whirlpool WMT55511K Instrucciones De Instalación

Unpacking Instructions

WARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other injury.
1. Unpack the microwave oven and check if all parts are
supplied and screw pack is included. See "Screw Pack
Supplied" and "Parts Supplied" sections. They are needed
for installation.
2. Dispose of/recycle all packing materials.
A
B
C
B
A. Carton box (1)
B. Angle bar (2)
C. Top cushion (1)
D. Small cushion (1)

Prepare Microwave Oven

1. Remove any loose items from inside the microwave oven.
2. Place the microwave oven on a stable surface with the door
slightly beyond the edge of the surface as shown.
B
A. Edge of table
B. Edge of microwave-lower front door
3. Attached the trim kit frame to the microwave oven in the
following steps:
Remove the protective film on door before installation.
■

INSTALLATION INSTRUCTIONS

D
E
F
G
E. Inner cushion (Standard
models only)
F. Inner cushion bar
(Standard models only)
G. Bottom cushion
A
Insert the four trim kit frame locating holes to the four
■
microwave oven locating pins. Install the trim kit frame in
the proper orientation. "TOP" side is marked.
C
B
A. Trim Kit Frame
B. Locating pin (4)
C. Locating hole (4)
Secure the trim kit frame to the microwave oven using
■
four #7-18x7/16" round-head sheet metal screws.
A. Trim Kit Frame
B. #7-18x7/16" round head sheet metal screw (4)
C. Screw holes (4)
4. Secure the two cooling ducts to the top of the microwave
oven using six #7-18x7/16" round-head sheet metal screws.
Standard
Slim
A. Cooling Duct (2)
B. #7-18x7/16" round head sheet metal screws (6)
C. Screw holes (6)
NOTE: The cooling duct may have slightly different
appearance, depending on your model.
A
A
B
C
7