INDUSTRIAS TECHNOFLEX KN-16 Manual De Instrucciones página 17

1.NEVER operate with the rammer for other
aplication that compact loose soils.
2.NEVER allow improperly trained people to
operate this equipment. People operating this
equipment must be familiar with the potential
risks and hazards associated with it.
3.NEVER touch engine or muffler while the
equipment is operating or inmediately after it
has been turned off. These areas get hot and
may be cause burns.
4.NO use accessories or attachtments, wich are
no recommended
TECHNOFLEX
Damage to equipment and/or injury to user
may result.
5.DO NOT touch any parts of the engine when it
is working or within short time after it stops, for
the temperature of these parts are very high
when it works. Satorage and transportation
after it is cooled is acceptable.
6. NEVER operate machine with the belt guard
missing. Exposed drive belt and pulleys create
potentially dangerous
hazards that can cause serious injuries.
7.NEVER leave machine running unattended.
8.NEVER run machine indoors or in an enclosed
area unless adequate ventilation, through such
items as exhaust fans or hoses, is provided.
Exhaust gas fram
poisonous carbon monoxide gas; exposure to
carbon monoxide
consciousness and may lead to death.
9.ALWAYS keep hands, feet, and loose clothing
away fram moving parts of equipment.
10.Keep your work area clean and free of clutter.
11.Keep your work area well lit.
12.NEVER operate motor in areas exposed to
flammable or explosive liquids or gases! The
motor brushes spark during operating and
could ignite fumes.
ENGLISH
by INDUSTRIAS
S.A. for this equipment.
the engine
can cause los
Save these instructions!
OPERATION
13.DO NOT allow children or people other
than the operator to handle power cables,
extension cords or the equipment.
14.DO NOT allow children or people other
than the operator to handle power cables,
extension cords or the equipment.
15.DO NOT allow non-essential personnel or
visitors in the work area.
16.Wear protective clothing when operating
equipment. Goggles or safety glasses will
protect against eye damage caused by
flying debris.
17.DO NOT force tool. Use the correct tool for
which it is designed.
18.NEVER allow untrained personnel to
operate or service the equipment.
19.Maintain tools with care. Keep machine
unit clean for better and safer performance.
Inspect motor cord periodically and if
damaged, have it repaired by an authorized
service facility.
20.NEVER use the motor with a defective
switch. If the switch does not turn the motor
"ON" or "OFF", have it repaired by an
authorized service facility before using the
motor.
21.Replace worn or damaged parts with
replacement
contains
recomended for use by INDUSTRIAS
TECHNOFLEX S.A.
s of
22.Any servicing, other than that covered in
this
performed by an authorized INDUSTRIAS
TECHNOFLEX S.A Service Representative.
23.NEVER operate the machine outside the
using
flammable environment is forbidden.
parts designed
instruction manual,
are; operate the
1B
and
should be
machine in
1B-3