COMENDA Prime PB 24 Serie Instrucciones Para El Uso Y El Mantenimiento página 30

ENGLISH
F2
INITIAL WATER FILLING
This warning is displayed when the machine is filling
water (only during regulation) (only with starting
temperature management active).
C1
SELF-WASHING CYCLE
This warning is displayed when the machine is carrying
out the SELF-WASHING cycle..
C2
DRAIN CYCLE
This warning is displayed when the
machine is carrying out the DRAIN CYCLE
C3
REGENERATION
This warning is displayed when the machine is carrying
out the REGENERATION.
10
11
13
12
28
Part 3: Reserved for technician
3.3 PERISTALTIC DETERGENT/RINSE
AGENT DISPENSER PUMP (Fig.8)
The machine is equipped with an automatic detergent and
rinse agent dispenser pump.
Dispensing of detergent and rinse agent is managed both
during the regulation and restoration phases. The amount of
detergent/rinse agent is identified during the installation phase
by the authorised technician and is suited to the water volume
and hardness. At each rinse cycle, the machine restores
the detergent and rinse agent values foreseen by the
manufacturer.
To fill the dispenser, proceed as follows:
• Insert the supply tube (11/13) in the tank (10/12).
• Start the machine and check that the dispenser draws
from the tank
• The dispenser is filled during the cycle by slightly opening
and closing the door, a few times, until you see that the
tube is completely filled.
ATTENTION
I
f the detergent comes in contact with skin, wash with
plenty of running water or, more precisely, refer to the
specific indications according to the type of detergent used.
• The detergent enters automatically every time the tank
is filled with water.
• Water droplets on glass indicate insufficient dosage, while
stripes or dotting indicate excessive dosage.
• To adjust dosage, act on the pin, rotating it clockwise to
decrease the amount and anticlockwise to increase
IMPORTANT
T
hese data are indicative and not binding, as they can
change depending on the hardness of the water, and the
type of detergent and rinse agent used.
ATTENTION
I
f you change the product used (detergent or rinse agent)
it is recommended to wash the dispensing system with
water and then to fill the dispensers.