Cleaning And Maintenance - Jimmy JV35 Manual De Usuario

Cleaning and Maintenance

Notice:
1. Filters are available at dealers.
2. It is recommended to clean the dust cup after each
use. when the filter is blocked due to excessive dust
accumulation, it needs to be cleaned and replaced if
necessary.
Dust Cup Cleaning
1. Turn off the machine and unplug the power
cord. Then press the release button and lift
upward (Figure 1).
2. Twist dust dust lid anticlockwise (Figure 2) and
remove it from dust cup to clean (Figure 3).
3. Do Not tap the filter in reverse in case of dust
clog. Clean filter and cyclone regularly for
better use.
4. After cleaning, assemble parts in reverse
order. Do Not miss the filter, filter missing can
cause product failure.
Notice: Use water or neutral reagents to clean dust cup
and wipe with dry cloths. The filter cannot be
washed. Make sure the filter and dust cup are
completely dry before another use.
Brushroll Cleaning
Turn off the machine and unplug the power
cord, rotate the lock knob with a coin or flat-
blade screwdriver from locked position to unlock
position (Figure 5) to remove the cover and
roller brush (Figure 6).
After cleaning, snap the hex-gear side into the
base first (Figure 7) and press the other side
(Figure 8). Install the cover in reverse order of
removing.
Notice: For safety reasons, please turn off the machine
and unplug power cord before cleaning
brushroll.
1
Dust Cup Release
Button
3
Dust
Cup Lid
Brush
4
Tapping Downward
6
Brushroll
Brushroll Cover
7-2
Hex-side Four-corner Side
2
Filter
Cyclone
5
7-1
Hex-gear
8
Belt
3