Metabo 6.31213 Manual De Uso página 6

en ENGLISH
- Mount guide plate 6.31019 on the guide rail. (The
groove (9) in the guide plate 6.31019 slides in the
profile (3) of the guide rail)
- Mount the circular saw with bores of the guide
plate on the pins (10) of the guide plate 6.31019.
- With the screws (8) released, the play, and thus
the sliding movement of the guide rail, can be
adjusted by shifting the screws.
The guide plate has several bores, which also
makes the machine suitable for diagonal cuts along
the guide rail. The cutting angles are annotated
beside the bores.
4. Jigsaws
Guide device 6.31249 must be used for this
application.
See page 2, fig. G.
- Push the guide rule (13) of the guide device into
the T-slot (14) of the guide rail.
- If necessary, adjust the play of the guide rule (13)
in the groove using the two threaded pins of the
guide rule.
- Take the splinter guard plate from the guide plate
of the jigsaw (the splinter guard plate (12) inserted
in the guide device is used).
- If necessary, adjust the parallelism of the guide rail
after releasing the screws (11). Tighten the
screws (11) again.
- Then insert the jigsaw in the guide device.
STE 140, STE 140 Plus, STEB 140,
STEB 140 Plus, STA 18 LTX 140
For usage, the guard plate (plastic: 6.23595, felt:
6.23596, Pertinax: 6.23597) with laterally inserted
and engaged guide rail adapter is necessary.
5. Routers
Of 528 / Of E 529 / Of E 728, OFE 738, Of 1028/ Of
E 1229 Signal:
Guide device 6.31248 and spacer plate 6.31503
must be used for this application.
See page 2, fig. H.
- Fit the spacer plate 6.31503 at the sole plate of the
router.
- Insert the guide device in the guide plate of the
router.
- Push the guide rule (15) into the T-slot (14) of the
guide rail.
- If necessary, adjust the play of the guide rule (15)
in the groove using the two threaded pins of the
guide rule.
- Release the wing screws on the router and make
a rough setting of the desired distance between
router and guide rail. Tighten the wing screws
again.
- Lower the motor section of the router so that the
router is near the scribe mark. Fix the motor
section in this position.
6
- Fine adjustment: release screws (16). By turning
the wing screw (17), the position of the router in
relation to the scribe mark - according to the scale
gradations - can be finely adjusted. Tighten the
screws (16) again.