Craftsman 1150 Serie Manual Del Operador página 8

3. The chipper shredder was shipped with one end of the support brace already
secured to the lower frame. Loosen but do not remove the bolts securing the
brace to the frame.
4. A. Align the holes in the chute with the holes in the top of the brace and
attach brace to chipper chute with hardware previously removed. The
flat washers should be placed under the bolt heads and against the
inside surface of the plastic chipper chute. Tighten securely. See Figure 7.
A
B
B Tighten the bolts securing the support brace to the frame.
C. Tighten the three nuts on the weld studs holding the chipper chute to
the impeller housing.
C
Figure 7
ASSEMBLY
Attaching The Bag
1. To attach the bag:
A. Place the opening of the bag completely over the chute deflector.
B. Pull on the drawstring until the bag is tight around chute deflector
opening.
C. Clip drawstring back on itself, tight against chute deflector to secure
into position. See Figure 8.
B
8
C
A
Figure 8