Getting Started; Step 1: Charging The Battery Pack - Sony Handycam DCR-SR47 Guía De Operaciónes

Getting started

Step 1: Charging the battery pack

CHG (charge) lamp
You can charge the "InfoLITHIUM" battery pack (H series) after attaching it to your
camcorder.
You cannot attach any "InfoLITHIUM" battery pack other than the H series to your camcorder.

1
Turn off your camcorder by closing the LCD screen.
2
Attach the battery pack by sliding it in the direction of the arrow until it
clicks.
3
Connect the AC Adaptor and the power cord (mains lead) to your
camcorder and the wall outlet (wall socket).
Be sure that the  mark on the DC plug is facing down.

The CHG (charge) lamp lights up and charging starts. The CHG (charge) lamp turns off
when the battery pack is fully charged.
4
When the battery is charged, disconnect the AC Adaptor from the DC IN
jack of your camcorder.
See page 52 on charging, recording and playing time.

ACCESS lamp (Hard disk)
DC plug
DC IN jack
AC Adaptor
Power cord (Mains lead)
Battery pack
To the wall outlet
(wall socket)
US
1