PLYMOVENT DRAFTMAX BASIC Manual De Instalación Y De Manejo página 10

- washer (6)
The Silencer/outlet duct can be connected to the HEPA kit or
directly to the downdraft table.
To mount the silencer/outlet duct, proceed as follows.
Fig. 4.6
• If necessary: unscrew the outlet panel of the downdraft
table or the outlet panel of the HEPA kit; keep the 4 bolts.
• Apply the draught strip to the downdraft table (A) or HEPA
kit (B).
• Put bolts (C) halfway through the 2 lower holes at the outlet
of the downdraft table or HEPA box.
A
C (x2)
Fig. 4.6: Draught strip + bolts
Fig. 4.7
• Put the lower shaft (B) of the silencer/outlet duct over the
bolts (C).
• Move it in an upright position and put a bolt (A) in the 2
upper holes.
• Fasten the lower shaft by tightening the 4 bolts.
A
B
C
Fig. 4.7: Mounting of the lower shaft
Fig. 4.8
• Put the upper shaft (A) on top of the lower shaft (B).
• Fasten it with the 6 bolts + washers (C).
0507060400/151013/G DraftMax Basic | DraftMax Advance | DraftMax Ultra
B
A
B
Fig. 4.8: Mounting of the upper shaft
The outlet panel of the downdraft table becomes redundant.
4.2.8 Working light
The working light consists of:
- lighting fixture with 2,3 m of cable and plug
- 6 bolts M6
- 3 tie-wraps
To mount the working light, proceed as follows.
Fig. 4.9
• Mount the lighting fixture using the 6 bolts (A).
• Lead the cable down the back side of the downdraft table.
• Attach the cable to the back panel or backdraft panel using
the 3 tie-wraps (B).
• Connect the cable (refer to Fig. 2.3B).
Fig. 4.9: Connection of working light
C (6x)
A (x6)
B (x3)
EN - 9