What You Need - Tru-Test HD5T Guia De Inicio Rapido

3

What you need

 Lifting equipment to lift your crush/chute safely
 8 x 12 mm (7/16") bolts and Nyloc* nuts for the load bar mounting plates. The
length of the bolts will depend on the distance needed to bolt the load bar
mounting plates under the crush/chute.
Power drill

A 12 mm (1/2") masonry drill bit

Hammer

Socket set

 Adjustable spanner
 Level
 Plastic casing/conduit for the indicator cable
 Cable ties
 A torque wrench with an 12 mm (7/16") fitting (optional). A torque wrench will
only be needed if you need to swivel the load bar feet and tighten them up again.
 A weigh scale indicator upgraded to the software version shown in
system
, and fully charged.
You may also need adaptor plates to install the HD5T load bars under
your crush/chute. Adapt the length of the bolts for the load bar
mounting plates accordingly.
If you don't want the load bar feet to extend beyond the load bar, you
can loosen the bolt in the centre of the load bar foot, swivel the foot
around, and tighten with a torque wrench to a setting of 50 Nm (37
ft-lbs).
HD5T load bar dimensions are available from www.tru-test.com
4
The weighing