Publicidad
Idiomas disponibles
Idiomas disponibles
• When installing the belt, make sure that the
direction of the arrow on the back of the belt
corresponds to the one on the tool itself.
Adjusting belt tracking
1
1. Adjusting knob
2
While the belt is running, use the adjusting
knob to center the belt tracking. Failure to do
so can result in frayed belt edges and wear on
the sander frame.
Dust bag
1. Dust bag 2. Dust spout
Attach the dust bag onto the dust spout. The
dust spout is tapered. When attaching the dust
bag, push it onto the dust spout firmly as far
as it will go to prevent it from coming off during
operation.
1
1
1
2
2
1
2
1. Fastener
When the dust bag is about half full, remove
the dust bag from the tool and pull the fastener
out. Empty the dust bag of its contents, tapping
it lightly so as to remove particles adhering
to the insides which might hamper further
collection.
NOTE:
• If you connect a TAKIMA vacuum cleaner to
this tool, more efficient and cleaner operations
can be performed.
Carbon plate (optional accessory)
1
1
1. Steel plate 2. Carbon plate 3. Strap washer
For greater sanding efficiency and to help the
belt run cooler, install an optional carbon plate
on the steel plate when sanding hardwood or
steel.
6
1
1
1
2
2
3
Publicidad
